![]() I sanded the insides of the holes with my oscillating spindle sander and rounded the edges of the holes over with a 1/4 inch rounder bit in my router. Once the holes are drilled I cut along the outside lines of the rectangle with my jig saw and connected the two holes to make one large handle hole in each of the boards. After you’ve removed all the center blocks, then tap an outside block to the center for tower stability and then remove another block. Use your left hand to push the blocks through if you’re right-handed or vice-versa. Using a 2 inch forstner bit I drilled 2 holes in each board on the 2 center points I marked on the rectangle that were 1 inch in from the end. Push the blocks through the tower and don’t pull them. These points will act as center marks for the holes that will be drilled I marked a center line horizontally across the rectangle and marked a point 1 inch in from each side. From the center I measured 3 inches in each direction, marked 2 lines, measured down 4 inches from the top and marked a line across the board, measured 2 inches down from the top and marked another line across.įor the handles I first laid out a rectangle that was centered on each of the side boards 6 inches wide, 2 inches tall, and 2 inches down from the top of the board. ![]() Next, sand all the edges so everything is smooth and can slide easily across each other. Try to avoid wood that has large knots or holes in it. You can cut the boards yourself or have them cut at your local lumber yard. In this article, I am reviewing five of the best large Jenga sets on the market to help you pick the best one for your next outdoor party. Stock Level: LOW Giant Lawn Jenga is the perfect lawn game and will keep the entire family entertained for hours. For the layout of the handles I first found the center point of both the left and right side boards. First, you need to buy enough 2×4 boards to cut into forty-eight 10 1/2 inch pieces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |